Siemens FS20 - Battery Kit (9 V) [FR]; Installation in the Eco and Standard Housings

Mounting and installation of the compact control panels
Battery kit (9 V) [FR]
5
113 |
354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.8 Battery kit (9 V) [FR]
5.8.1 Installation in the Eco and Standard housings
Figure 51: Mounting of battery kit FCA2010-F1 in Eco and Standard housing
1 Power supply (70 W), if installed
2 Battery holder
3 Fixing screws
4 Battery, 9 V block type E
X1 Battery kit connection (9 V)
Mounting steps
1. Position the battery holder (2) under the power supply (1).
2. Fasten the battery holder using the two screws (3).
3. Connect the cable of the battery kit according to the pin assignment.
4. Insert the battery (4). Observe correct polarity.
1
2
3
4
X1