Mounting and installation of the compact control panels
5
212 | 354
5.28 RT interface [CH]
5.28.1 Installation
The RT interface FCI2006-C1 [CH] is delivered as a complete set incl. connection
cables. The RT interface is already inserted onto the mounting plate in the card
cage. The cables are connected and pre-assembled.
Figure 114: Installation example of the RT interface FCI2006-C1
1 Hinge angle on mounting plate
2 Fork head (2 pieces)
3 M5 x 5 hexagon nut (2 pieces)
4 M5 hex spacers (2 pieces)
5 Mounting holes in housing rear panel
6 Fastening clamp (2 pieces)
7 Distance piece, circular
8 Safety washer (pre-mounted)
9 M4 x 14 fixing screw (pre-mounted)
10 Mounting plate set with RT interface FCI2006-C1, incl. pre-mounted cables
11 Connection cable for the RT device (fixed with cable tie)
12 Connection cable to the periphery board (guided through the cable duct)
13 Cable duct
1
2
3
4
5
6
To Next Page
Loading...
