Siemens FS20 - Pin Assignments

Mounting and installation of the compact control panels
Redux module [DE]
5
196 | 354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.23.2 Pin assignments
The pin assignment of the Redux module is listed in the manual of the Redux
module.
During connection please observe the following:
● The data cables of the Redux module are connected to the RS485 interface.
● The supply of the Redux module is connected to the periphery board.
– Periphery board (2 loops) FCI2002-A1: Supply output 2 on plug X9
– Periphery board (4 loops) FCI2004-A1: Supply output 1 on plug X8
● The fault output of the Redux module can be connected to any I/O on the
periphery board. The I/O must be configured accordingly.