Siemens FS20 - Mounting on DIN Rail or Mounting Plate

Mounting and installation of the compact control panels
Modes of mounting for modules
5
203 |
354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.26.1 Mounting on DIN rail or mounting plate
NOTICE
Short mounting distance
Module overheating
● There must be an air gap of at least 1 cm above the cover cap of the module.
● There must be a minimum distance of 1 cm between two modules or any
other object.
If you are installing the module without the housing, proceed as follows:
1. Use two screws to mount the module on a flat surface or use two mounting feet
FDCM291 to mount on a DIN rail.
The cover cap must be transparent to allow the LEDs to be seen at all times.
Pick a suitable mounting position, ensuring that the LEDs will remain visible at
all times during operation.
2. Connect the cables to the corresponding terminals. Only connect one wire per
terminal.
3. Fix the cables to the module by means of cable ties.
Figure 110: Mounting feet FDCM291
Figure 111: Mounting on DIN rail or mounting plate