Mounting and installation FC2080
Installing the fiber optic cable network module
6
322 | 354
6.15 Installing the fiber optic cable network module
6.15.1 Installation
The identical fiber optic cable network modules FN2006-A1 and FN2007-A1 can be
installed on a DIN rail either horizontally or vertically. To do this, the DIN rail clips
must be changed from the rear side to the rear face. When the clips are removed,
installation on a plate is also possible. The following example shows the horizontal
installation on a DIN rail.
Figure 179: Installation example of the fiber optic cable network module in the FC2080
1 Fiber optic cable network module
2 Additional DIN rail with terminal block and locking clamps (if required)
3 Carrier on the right-hand side wall
Example of installation
1. Install an additional DIN rail (2), if required with a terminal block and locking
clamps as shown in the example, on the carrier of the right-hand side wall (3).
2. Install the fiber optic cable network module (1) on the DIN rail (2).
3. Wire the fiber optic cable network module according to the planner's
specifications.
You will find detailed information regarding wiring and pin assignment of the
electrical and optical connections in the document 008837, Product data.
2 3
1
To Next Page
Loading...
