Siemens FS20 - DIN Rail Clip Mounting

Mounting and installation of the compact control panels
Installing an Ethernet switch (modular) FN2012
5
143 |
354
Building Technologies
008851_s_en_
--
Fire Safety
2016
-
01
-
27
5.16.2 DIN rail clip mounting
The diagram below shows how to mount the DIN rail clip on the FN2012.
1 2x countersunk screws
2 DIN rail clip in mounting position
3 4x spacers with thread for fixing the DIN rail clip
4 Ethernet switch (modular) FN2012
5 Flange with retaining clamp
1. Place the DIN rail clip (2) in the required mounting position relative to the
FN2012 (4) so that the flange with the retaining clamp (5) is at the bottom.
2. Fasten the DIN rail clip (2) using both countersunk screws (1) at the
spacers (3) located one above the other.
1
5
3
4
2