Installing the key safe adapter [DE]
6
315 |
Building Technologies
Example of installation
1. Mount the key safe adapter (6) on the carriers of the right-hand side wall (1).
2. Mount an additional DIN rail (3) on the right-hand side wall as shown in the
example.
3. If you use an I/O module FDCIO224 (2), install it on the DIN rail together with
an additional terminal block (5) using standard locking clamps (4).
If you use an I/O card, this point does not apply.
4. Wire the components according to their individual wiring diagram or as per the
following wiring examples.
To Next Page
Loading...
