Siemens RUGGEDCOM WIN5123 - Configuring Null Authentication

RUGGEDCOM WIN
User Guide
Chapter 5
Setup and Configuration
Configuring Null Authentication 95
Figure93:Authentication Method screen
2. Click Set TTLS. The EAP TTLS screen appears.
Figure94:EAP TTLS Screen
3. Configure the following parameter(s) as required:
Parameter Description
Realm The EAP-TTLS authentication realm.
Username The EAP-TTLS user name.
Password The password for the EAP-TTLS user.
Confirm Password The password for the EAP-TTLS user, retyped to confirm it.
4. Click Apply.
5. Reboot the device. For more information, refer to Section4.5, “Rebooting the Device” .
Section5.19.4
Configuring Null Authentication
To enable null authentication, do the following:
1. Navigate to WiMAX» Authentication. The Authentication Method screen appears.