Siemens RUGGEDCOM WIN5123 - Managing Alarms

RUGGEDCOM WIN
User Guide
Chapter 4
System Administration
Managing Alarms 45
Section4.10
Managing Alarms
This section describes how to configure and manage alarms.
CONTENTS
• Section4.10.1, “Viewing Alarms”
• Section4.10.2, “Clearing Alarms”
Section4.10.1
Viewing Alarms
To view current system alarms, navigate to Management» Alarms and Traps. The System Alarms screen
appears.
Figure41:System Alarms Screen
The table provides the following information:
Parameter Description
Number of Critical Alarms Displays the number of critical alarms.
Number of Major Alarms Displays the number of major alarms.
Number of Warning Alarms Displays the number of warning or advisory alarms.
The table provides the following information:
Parameter Description
ID Displays the alarm type identification number.
Name Displays the alarm type. For a list of alarm and trap conditions, refer to Section5.12.2.3,
“Viewing a List of Traps” .
Status Synopsis:  {On, Off}
Indicates if the alarm type is enabled or disabled.