Siemens RUGGEDCOM WIN5123 - Disconnecting from the Base Station

Chapter 5
Setup and Configuration
RUGGEDCOM WIN
User Guide
56 Disconnecting from the Base Station
Figure48:System Functions Screen
3. Click Connect.
Section5.2.4
Disconnecting from the Base Station
To disconnect from base stations, do the following:
CAUTION!
Connection Loss Hazard - Risk of data loss or failure of functioning processes. Clicking Disconnect
while using the RF interface will stop the RUGGEDCOM WIN from transmitting and the RUGGEDCOM
WIN will lose its connection to the base station(s). A hard reset (shutting down and then powering
up) or a site visit will be required to reboot the RUGGEDCOM WIN using the GUI. Before clicking
Disconnect, make sure you are not using the RF Interface.
1. Navigate to Management» System Functions. The System Functions screen appears.