Siemens RUGGEDCOM WIN5123 - Configuring the Primary Software Version

RUGGEDCOM WIN
User Guide
Chapter 3
Device Management
Configuring the Primary Software Version 27
Figure18:SW Properties Screen
2. Click Run Secondary. The device reboots, and runs the Secondary software image.
Section3.4.5
Configuring the Primary Software Version
To configure the currently running software image as the Primary software image (and switch the designation
from being the Secondary image), do the following:
1. Navigate to Management» SW Upgrade. The SW Properties screen appears.
Figure19:SW Properties Screen
2. Click Set as Primary.