Siemens RUGGEDCOM WIN5123 - Adding Base Station Identifiers

RUGGEDCOM WIN
User Guide
Chapter 5
Setup and Configuration
Adding Base Station Identifiers 59
2
1
3 4
6
7
8
5
Figure51:Allowed BS Screen
1.Connect only to allowed BS List 2.Allowed BS List Table 3.Add Button 4.Delete Button 5.Connect only to allowed
Operator ID Box 6.Apply Button 7.Connect Button 8.Disconnect Button
2. In the Connect only to allowed BS list, select Enable or Disable.
3. Click Apply.
Section5.3.2
Adding Base Station Identifiers
To add base station identifiers, do the following:
NOTE
Do not make changes to the Allowed BS List table if the RUGGEDCOM WIN is in scanning mode.
Click Disconnect before adding base stations. Do not click Disconnect if using the RF Interface. This
will stop the SS from transmitting and the RUGGEDCOM WIN will lose its connection to the base
station(s). A hard reset (shutting down and then powering up) or a site visit will be required to reboot
the RUGGEDCOM WIN using the GUI.
For more information about disconnecting, refer to Section5.3.5, “Disconnecting from Specific Base
Stations” .
1. Navigate to WiMAX» Allowed BS. The Allowed BS screen appears.