Siemens RUGGEDCOM WIN5123 - Deleting Snmpv3 Users

RUGGEDCOM WIN
User Guide
Chapter 5
Setup and Configuration
Deleting SNMPv3 Users 79
1 2
Figure72:SNMPv3 Configuration Screen
1.Add 2.Delete
3. Click Add. A new row appears in the Users Table.
4. Configure the following parameter(s) as required:
Parameter Description
Username The user name.
Authentication Passphrase The passphrase used for authentication.
Authentication Protocol Synopsis:  {HMAC-SHA1}
The authentication protocol for the user.
Privacy Passphrase The passphrase used for privacy.
Privacy Protocol Synopsis:  {CBC-DES}
The privacy protocol.
Access Group Associate the user with an SNMPv3 Access Group.
5. Click Apply.
Section5.12.4.2
Deleting SNMPv3 Users
To delete an SNMPv3 user, do the following:
1. Navigate to Management» SNMP. The SNMP General Settings screen appears.
2. Click SNMPv3 Configuration. The SNMPv3 Configuration screen appears.