Siemens RUGGEDCOM WIN5123 - Connecting to the Base Station

RUGGEDCOM WIN
User Guide
Chapter 5
Setup and Configuration
Connecting to the Base Station 55
1 2
Figure47:Scanner Settings Screen
1.Add 2.Delete
2. Select a row and click Delete to remove a row from the table.
Or
Click Delete All to delete all scanning configuration information.
3. Click Apply.
Section5.2.3
Connecting to the Base Station
To connect to base stations, do the following:
1. If this is the first time connecting to a base station, you must configure the scanner first. For more
information, refer to Section5.2.1, “Configuring the Scanner” .
2. Navigate to Management» System Functions. The System Functions screen appears.