Siemens RUGGEDCOM WIN5123 - Deleting SNMP Traps

RUGGEDCOM WIN
User Guide
Chapter 5
Setup and Configuration
Deleting SNMP Traps 73
1 2
Figure66:SNMP General Settings
1.Add 2.Delete
2. Click Add. A new row appears in the Managers Table.
3. Type an IP address in the new row.
4. Click Apply.
Section5.12.2.2
Deleting SNMP Traps
To delete SNMP traps, do the following:
1. Navigate to Management» SNMP. The SNMP General Settings screen appears.