Siemens RUGGEDCOM WIN5123 - Copying Files to the Secondary Bank

RUGGEDCOM WIN
User Guide
Chapter 3
Device Management
Copying Files to the Secondary Bank 31
Figure24:Secondary Components Screen
2. Select a file from the table.
3. Click Upload File.
4. View the status of the operation. For more information, refer to Section3.4.8, “Viewing the Status of an
Operation” .
Section3.4.7.3
Copying Files to the Secondary Bank
To copy files to the secondary bank, do the following:
1. Navigate to Management» SW Upgrade» Primary Bank. The Primary Components screen appears.
Figure25:Primary Components Screen
2. Select a file from the table.
NOTE
Before copying the file, make sure it does not already exist in the Secondary memory bank. If the
file is present in the Secondary memory bank, delete the file from the Secondary memory bank
before copying. For more information, refer to Section3.4.7.4, “Deleting Memory Bank Files” .