1PosSSI/Digital
5.2 Brief Introduction to Commissioning the 1PosSSI/Digital
ET 200S Positioning
Operating Instructions, 05/2007, A5E00124871-04
191
Installation, Wiring, and Fitting
Install and wire the TM-E30S44-01 terminal module. Insert the 1PosSSI/Digital in the
terminal module (you can find detailed instructions in the
Distributed I/O Device
manual).
Terminal assignment View Remarks
Connection of the SSI Encoder:
Terminals 1-8
Connection of the Switches and the
Drive: Terminals 9-16
1: D 9: IN0 Minus limit switch
5: /D
Data from the SSI
encoder
13: IN1 Plus limit switch
3: B 14: IN2 Latch signal
7: /B
Unused terminals
10: 24 VDC Encoder supply for
the switches
2: 24 V DC 11: OUT0 Travel minus or rapid
feed
6: M
Power supply for
SSI encoder
12: OUT1 Travel plus or creep
feed
4: C 16: OUT2 Rapid/creep feed and
travel plus/minus
6)
326
66,'LJLWDO
(6'+$%
326
83 '1
66,
'
'
'&9
0
&
&
8:/C
SSI clock (clock
line)
15: 2L+ Load voltage infeed
for OUT0, OUT1 and
OUT2
To Next Page
Loading...
