TeleControl
6.1 SIMATIC RTU3000C
Industrial Ethernet
292 System Manual, 09/2019, C79000-G8976-C242-10
12 - 24 V DC via the power supply unit. Optional modules are available for energy self-
sufficient use cases: An accumulator with a solar panel or up to six redundant connectable
battery modules. All options can be combined with each other.
The RTUs can be used for monitoring the following systems:
● Pumping stations and water storage for the detection of leaks
● Irrigation systems for gauge monitoring of standing and flowing waters
● Flood protection
● Remote inventory monitoring of levels in tanks and silos
● Wind measurements for design of wind turbines
● Positioning, for example, monitoring of floating buoys
You can find further telecontrol modules such as TIM 3V-IE, CP 1243-8 or TIM 1531 in
section "Communications processors for SIMATIC S7 (Page 309)".
Example of a topology
Figure 6-2 Example of a topology for the TeleControl network: SIMATIC RTU3031C connection incl. GPS positioning at a
control center
To Next Page
Loading...
Need help?
General
