Siemens SIMATIC NET System Manual

TeleControl
6.4 Interfaces
Industrial Ethernet
System Manual, 09/2019, C79000-G8976-C242-10
295
RTU3010C
RTU3030C
RTU3031C
RTU3041C
Slot for SIM card
-
●
●
●
C-PLUG slot
-
-
-
-
● Suitable / available or according to the
specified standard
1)
A redundant power supply is possible through parallel connection to multiple energy suppliers: Combination of external
power supply/battery modules/battery
Functions
All devices have the following functions:
● Web Based Management
● Configuration of the IP address with DHCP
● Communication with the master station with TeleControl Basic, SINAUT ST7, DNP3, IEC
60870-5-104
● NTP
● SNTP
● DHCP client
● OpenVPN
6.4 Interfaces
Device
RTU3010C
RTU3030C
RTU3031C
RTU3041C
Voltage supply via 5-pin plug-in
terminal strip
1 1 1 1
Digital inputs (DI) / of which
counter inputs
8 / 2 8 / 2 8 / 2 8 / 2
Digital outputs (DO)
4
4
8
8
Digital outputs (AI)
4
4
4
4
Analog inputs
-
-
2
2
Ethernet interface 10/100 Mbps
for connection to external router
1x RJ45
1)
1x RJ45
1)
1x RJ45
1)
1x RJ45
1)
Antenna connection mobile wire-
less
- 1x SMA socket 1x SMA socket 1x SMA socket
Antenna connector GPS
-
-
1x SMA socket
1x SMA socket
Connection for battery modules
Max. 2x 3
Max. 2x 3
Max. 2x 3
Max. 2x 3
1)
The LAN connector is not suitable for direct connection of the RTU to the Internet. To do this, an external router with
suitable security mechanisms must be connected.

Siemens SIMATIC NET Specifications

General

Category	Industrial Communication Software
Manufacturer	Siemens
Operating Systems	Windows, Linux
Protocols Supported	PROFIBUS, PROFINET, OPC UA
Compatibility	Siemens PLCs, Third-party devices with supported protocols