EasyManuals Logo

Siemens SIMATIC NET System Manual

Siemens SIMATIC NET
372 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #343 background imageLoading...
Page #343 background image
Industrial Ethernet
System Manual, 09/2019, C79000-G8976-C242-10
343
Compact switch module
9
Overview
The Compact Switch Modules are industrial Ethernet switches with a compact, modular
design for use in the immediate vicinity of the SIMATIC S7 CPUs. Using a CSM, the
Ethernet interface of a SIMATIC S7 CPU can be multiplied. This means that simultaneous
communication with operator control and programming devices, other controllers or office
networks is possible.
With a CSM and the SIMATIC S7 controller, simple, low-cost automation networks can be
implemented.
Device versions
Currently, there are four device types of the Compact Switch Module available. These differ
in terms of their construction and the installation options:
The CSM 377 unmanaged meets the requirements of rugged SIMATIC S7-300
technology and is installed on an S7-300 standard rail. The module is designed according
to the standards EN 61000-6-2:2001 and EN 61000-6-4:2001.
The CSM 1277 unmanaged corresponds to the industrial, technical requirements of the
new SIMATIC generation S7-1200. It is intended for installation on a S7-1200 standard
rail. The module conforms with the standards EN 61000-6-2 and EN 61000-6-4.
The SIPLUS NET CSM 1277 is an unmanaged switch for unusual environmental
conditions. The module is in conformity with the standards EN 60721-3-3 of the class
3B2, EN 60721-3-3 of the class 3C4 incl. salt spray as well as the ISA S71.04, the
immunity test levels G1, G2, G3 and GX.
LOGO! CSM is designed with four RJ45 ports for external access or connection to
Industrial Ethernet networks. With the LOGO! CMS an Ethernet interface of the SIMATIC
LOGO! system modules can be multiplied. This means that simultaneous communication
with operator control and programming devices, other controllers or office environments
is possible.
It is installed on a standard rail.
Two product variants are available:
LOGO! CSM 12/24 for operation with direct current at a voltage of 12 V and 24 V
LOGO! CSM 230 for the operation with an AC voltage of 110 V and 230 V

Table of Contents

Other manuals for Siemens SIMATIC NET

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SIMATIC NET and is the answer not in the manual?

Siemens SIMATIC NET Specifications

General IconGeneral
CategoryIndustrial Communication Software
ManufacturerSiemens
Operating SystemsWindows, Linux
Protocols SupportedPROFIBUS, PROFINET, OPC UA
CompatibilitySiemens PLCs, Third-party devices with supported protocols

Related product manuals