CPU and Input/Output Configuration
6-7
S7-200 Programmable Controller System Manual
A5E00066097-02
To access the pulse catch configuration screen, select the menu command
View > System Block from the main menu bar and click on the Pulse Catch Bits
tab. Figure 6-7 shows the Pulse Catch configuration screen. To enable the pulse
catch function on a particular input, click the corresponding checkbox.
System Block
OK Cancel
Configuration parameters must be downloaded before they take effect.
PasswordPort(s) Retentive Ranges
Analog Input Filters
Output Table Input Filters
Pulse Catch Bits
Background Time
Select desired inputs
I0.x
7 6 5 4 3 2 1 0
I1.x
Not all PLC types support every System Block option. Press F1 to see
which options are supported by each PLC.
Defaults
Figure 6-7 Pulse Catch Configuration Screen
To Next Page
Loading...
