IEC 1131-3 Instructions
10-23
S7-200 Programmable Controller System Manual
A5E00066097-02
10.7 IEC Move Instructions
Table 10-6 gives page references for the non-standard IEC Move instructions.
Table 10-6 Non-Standard IEC Move Instructions
Description
Page
Swap Instructions 9-105
Move Byte Immediate Read 9-106
Move Byte Immediate Write 9-106
Move
The Move and Assign Values function moves the value
IN to the address OUT. This instruction performs an
assignment operation. The input parameter is not
modified during execution.
The input and output data types can vary, but must be of
the same type.
Error conditions that set ENO = 0: SM4.3 (run-time),
0006 (indirect address)
Inputs/Outputs Operands Data Types
IN VB, IB, QB, MB, SB, SMB, LB, VW, IW, QW, MW, SM, SMW, LW, T,
C, AIW, VD, ID, QD, MD, SMD, SD, LD, HC, &VB, &IB, &QB, &MB,
&SB, AC, Constant, *VD, *AC, *LD
BYTE, WORD,
INT, DWORD,
DINT, REAL
OUT VB, IB, QB, MB, SB, SMB, LB, VW, IW, QW, MW, SW, SMW, LW, T,
C, AQW, VD, ID, QD, MD, SMD, SD, LD, AC, *VD, *AC, *LD
BYTE, WORD,
INT, DWORD,
DINT, REAL
L
A
D
F
B
D
MOVE
EN
IN OUT
ENO
222 224
✓✓✓
221
✓
226
To Next Page
Loading...
