Siemens SIMATIC S7-200 - Set Immediate, Reset Immediate (N Bits); No Operation

SIMATIC Instructions
9-8
S7-200 Programmable Controller System Manual
A5E00066097-02
Set Immediate, Reset Immediate (N Bits)
When the Set Immediate and Reset Immediate
instructions are executed, the specified number of
physical output points (N) starting at the bit or OUT are
immediately set (turned on) or immediately reset (turned
off).
The range of points that can be set or reset is 1 to 128.
The “I” indicates an immediate reference; the new value
is written to both the physical output point and the
corresponding process-image register location when the
instruction is executed. This differs from the
non-immediate references, which write the new value to
the process-image register only.
Error conditions that set ENO = 0:
SM4.3 (run-time), 0006 (indirect address), 0091 (operand
out of range)
Inputs/Outputs Operands Data Types
bit Q BOOL
N VB, IB, QB, MB, SMB, SB, LB, AC, Constant, *VD, *AC, *LD BYTE
No Operation
The No Operation instruction has no effect on the user
program execution. This instruction is not available in
FBD mode. The operand N is a number from 0 to 255.
Operands: N: Constant (0 to 255)
Data Types: BYTE
F
B
D
SI
RI
N
bit
SI
N
bit
RI
N
SI bit, N
RI bit, N
N
222 224
✓✓✓
221
L
A
D
S
T
L
bit
bit
226
✓
NOP N
N
NOP
222 224
✓✓✓
221
L
A
D
S
T
L
226
✓