Setting Up Communications Hardware and Network Communications
7-17
S7-200 Programmable Controller System Manual
A5E00066097-02
Communications Links
Double click the icon representing the PLC
you wish to communicate with.
Double click the interface icon to change to
communication parameters.
Double click the modem icon to setup the
modem parameters or dial to start modem
communications.
Communications Setup
Communication Parameters
Module PC/PPI cable (COM 1)
Protocol PPI
Local Address 0
Remote Address
Transmission Rate 9.6 kbps
PC/PPI cable
Address: 0
(None Selected)
Bausch Induline IL 4K4
(11-bit, 9600 Baud, Predefined)
Double-Click
to Refresh
Connect Modem
Mode 11-bit
2
Figure 7-11 Communications Setup Dialog Box
To Next Page
Loading...
