Siemens SIMATIC S7-200 - Set, Reset

IEC 1131-3 Instructions
10-5
S7-200 Programmable Controller System Manual
A5E00066097-02
Set, Reset
When Set and Reset are executed, the value specified
by the bit or OUT parameter is set or reset.
Error conditions that set ENO = 0: SM4.3 (run-time),
0006 (indirect address), 0091 (operand out of range)
Inputs/Outputs Operands Data Types
bit (LAD, FBD) I, Q, M, SM, T, C, V, S, L BOOL
Input (LAD) Power Flow BOOL
Input (FBD) I, Q, M, SM, T, C, V, S, L, Power Flow BOOL
bit
S
bit
R
S
R
222 224
✓✓✓
221
F
B
D
L
A
D
bit
bit
226
✓