Basic Concepts for Programming an S7-200 CPU
4-28
S7-200 Programmable Controller System Manual
A5E00066097-02
Configuring the CPU Password
You can use STEP 7-Micro/WIN 32 to create the password for the CPU. Select the
menu command View > System Block and click the Password tab. See
Figure 4-14. Enter the appropriate level of access for the CPU, then enter and
verify the password for the CPU.
System Block
PasswordPort(s) Retentive Ranges
OK Cancel
Configuration parameters must be downloaded before they take effect.
Not all PLC types support every System Block option. Press F1 to see which
options are supported by each PLC.
Analog Input Filters
Password:
Minimum Privileges (Level 3)
Partial Privileges (Level 2)
Verify:
Full Privileges (Level 1)
Pulse Catch Bits Background Time
Output Table
Input Filters
Figure 4-14 Configuring a Password for the CPU
To Next Page
Loading...
