Preface
iv
S7-200 Programmable Controller System Manual
A5E00066097-02
Scope of the Manual
The information contained in this manual pertains in particular to the following
products:
• S7-200 CPU models: CPU 221, CPU 222, and CPU 224 (firmware release 1.1),
and CPU 226 (firmware release 1.0).
• STEP 7Micro/WIN 32, version 3.1, a 32-bit programming software package for
Windows 95, Windows 98, and the Windows NT environment
• STEP 7Micro/WIN 32 Toolbox, a 32-bit programming software package for the
Windows 95, Windows 98, and the Windows NT 4.0 environment.
STEP 7Micro/WIN 32 Toolbox is designed for customers who use the S7-200
CPU with other microsystem components (such as the TP070 Touch Panel or a
MicroMaster drive).
Agency Approvals
The SIMATIC S7-200 series meets the following regulations:
• European Community (CE) Low Voltage Directive 73/23/EEC
• European Community (CE) EMC Directive 89/336/EEC
• Underwriters Laboratories, Inc.: UL 508 Listed (Industrial Control Equipment)
• Canadian Standards Association: CSA C22.2 Number 142 Certified (Process
Control Equipment)
• Factory Mutual Research: FM Class I, Division 2, Groups A, B, C, & D
Hazardous Locations, T4A and Class I, Zone 2, IIC, T4.
Refer to Appendix A for compliance information.
Related Information
Refer to the following for more detailed information about selected topics:
• STEP 7Micro/WIN 32 CD/disk: provides online help, the
STEP 7Micro/WIN
Getting Started
(a printable online manual), and Tips and Tricks projects.
• STEP 7Micro/WIN 32 Toolbox CD: provides the TP070 Touch Panel
Configuration Software, USS Protocol Instructions, online help, the
STEP 7Micro/WIN Getting Started
(a printable online manual), and Tips and
Tricks projects.
• Process Field Bus (PROFIBUS) standard (EN 50170): describes the standard
protocol for the S7-200 DP communication capability.
•
TD 200 Operator Interface User Manual:
describes how to install and use the
TD 200 with an S7-200 programmable logic controller.
To Next Page
Loading...
