Siemens SIMATIC S7-200 - Page 583

Index
Index-3
S7-200 Programmable Controller System Manual
A5E00066097-02
Comparison contact instructions
Compare Byte, 9-10
Compare Double Word, 9-12
Compare Equal, 10-8
Compare Greater Than, 10-10
Compare Greater Than or Equal, 10-10
Compare Integer, 9-11
Compare Less Than, 10-9
Compare Less Than or Equal, 10-9
Compare Not Equal, 10-8
Compare Real, 9-13
example, 9-14
Compiling, errors
rule violations, B-4
system response, 4-45
Configuration
communications hardware, 3-2, 7-3
creating drawings, 4-4
EM231 Analog module, A-43
EM235 Analog module, A-43
EM277 PROFIBUS–DP, A-54
of PC with CP card and programming
device, 7-12
of PC with MPI card and programming
device, 7-12
output states, 6-8
retentive ranges of memory, 5-19
Configuration location, analog modules, A-42
Connecting drives, 11-17
Connections, MPI logical, 7-30
Connector terminal identification
CPU 221 AC/DC/Relay, A-10
CPU 221 DC/DC/DC, A-10
CPU 222 AC/DC/Relay, A-15
CPU 222 DC/DC/DC, A-15
CPU 224 AC/DC/Relay, A-20
CPU 224 DC/DC/DC, A-20
CPU 226 AC/DC/Relay, A-25
CPU 226 DC/DC/DC, A-25
EM221 Digital Input 8 x 24VDC, A-27
EM222 Digital Output 8 x 24 VDC, A-29
EM222 Digital Output 8 x Relay, A-29
EM223 Digital Combination 16 In/16 Out,
A-38
EM223 Digital Combination 16 In/Relay
Out, A-38
EM223 Digital Combination 4 In/4 Out, A-32
EM223 Digital Combination 8 In/8 Out, A-35
EM223 Digital Combination 4 In/Relay Out,
A-32
EM223 Digital Combination 8 x 24 VDC/8 x
Relay, A-35
EM231 Analog 4 Inputs, A-41
EM231 Thermocouple, A-68
EM232 Analog 2 Outputs, A-41
EM235 Analog Combination 4 In/1 Out,
A-41
Connectors
bus expansion port, removing cover, 2-8
network, 7-33
order number, E-2
Considerations
hardware installation, 2-2–2-4
high-vibration environment, 2-7
using DIN rail stops, 2-7
using Watchdog Reset instruction, 9-146
vertical installations, 2-7
Constants, 5-12
Contact instructions
example, 9-5, 10-4
Negative Transition, 10-3
Not, 9-4
Positive Transition, 10-3
Reset Dominant Bistable, 10-7
Set Dominant Bistable, 10-7
standard contacts, 10-2
Control bits, High-Speed Counter, 9-37
Conventions, Mirco/WIN 32 programming, 8-2