S
S7 communication,109
SAFE,362
Safe Brake Relay,264
Safety function,184
Safety relay,104
Saw,326, 331
Scaling
Analog input,195
Analog output,199
SD (memory card),166
Formatting,166
Self-test,265
Sensor (electromechanical),103
Sequence control,186
Series commissioning,157, 270
Setpoint processing,184, 280
Setpoint source,184
Selecting,272, 273, 274
Settling time,127, 135, 143, 150
Shield plate,52
Short-circuit monitoring,340, 341
Signal interconnection,461
Sine-wave lter,35, 299
SIZER,467
Skip frequency band,279
Slip compensation,300
Smart Access,120
Speed
change with BOP-2,158
Limiting,280
Speed control,310
Spindle,127, 135, 142, 149
Square-law characteristic,302, 306
Standards
EN 61800-3,32
Star connection (Y),81
Startdrive,258
Download,120
Startdrive PC tool,258
STARTER
Download,120
STARTER PC tool,258
Starting behavior
Optimization,308
Starting behavior"; "Optimization,304
Starting current,305
State overview,186
Status word
Status word 1,214, 215, 233, 236
Status word 3,217
STO (Safe Torque O),255, 256
select,256
Storage medium,165
STW1 (control word 1),214, 232, 235
Subindex,220, 224, 225
Support,468
Switch o
Motor,187
OFF1 command,187
OFF2 command,187
OFF3 command,187
Switch on
Motor,187
ON command,187
Switching on inhibited,187, 214, 232, 235
Switch-o signal paths,265
Symbols,23
T
Technology controller,216, 253, 289
Temperature calculation,342
Temperature monitoring,339, 342
Temperature sensor,89
Temperature switch,340
Terminal block,188
Terminal strip,106
Factory setting,89
Test signals,263
Three-wire control,200
Tightening torque,54, 57, 59, 75
TN system,64
Torque accuracy,127, 135, 143, 150
TT system,64
Two-wire control,200
U
U/f characteristic,300
UL-compliant installation,77
Unit system,251
Update
Firmware,417
Upgrading the rmware,412
Upload
Data transfer,173
Download,172
Use for the intended purpose,27
Index
SINAMICS G120C Converters
Operating Instructions, 02/2023, FW V4.7 SP14, A5E34263257B AK 473
To Next Page
Loading...
Need help?
General
