Siemens SINAMICS PERFECT HARMONY GH180 - Page 116

Table 6-22 Internal I/O Module 2 (2807) Parameters
Parameter ID Unit Default Min Max Description
Module Type 2802 0 0 2 Set the type for internal I/O module 2. 0 = no
module installed.
Voltage 2562 V 120 -200 200 Set the required module voltage. Possible op‐
tions are:
• 24 V
• 120 V
Int Analog In4 2689 Submenu Access the setup menu for internal analog in‐
put 4.
See Table Internal Analog Input 4 Menu (2689).
Int Analog In5 2693 Submenu Access the setup menu for internal analog in‐
put 5.
See Table Internal Analog Input 5 Menu (2693).
Int Analog In6 2701 Submenu Access the setup menu for internal analog in‐
put 6.
See Table Internal Analog Input 6 Menu (2701).
Int Analog Out3 2645 Submenu Access the setup menu for internal analog out‐
put 3.
See Table Internal Analog Output 3 Menu
(2645).
Int Analog Out4 2653 Submenu Access the setup menu for internal analog out‐
put 4.
See Table Internal Analog Output 4 Menu
(2653).
Table 6-23 Internal I/O Module 3 (2808) Parameters
Parameter ID Unit Default Min Max Description
Module Type 2803 0 0 2 Set the type for internal I/O module 3. 0 = no
module installed.
Voltage 2563 V 120 -200 200 Set the required module voltage. Possible op‐
tions are:
• 24 V
• 120 V
Int Analog In7 2705 Submenu Access the setup menu for internal analog in‐
put 7.
See Table Internal Analog Input 7 Menu (2705).
Int Analog In8 2711 Submenu Access the setup menu for internal analog in‐
put 8.
See Table Internal Analog Input 8 Menu (2711).
Int Analog In9 2715 Submenu Access the setup menu for internal analog in‐
put 9.
See Table Internal Analog Input 9 Menu (2715).
Parameter Assignment/Addressing
6.6 Options for Drive Menu (2) - second part
NXGPro+ Control Manual
114 Operating Manual, A5E50491925A