Siemens SINAMICS PERFECT HARMONY GH180 - Page 117

Parameter ID Unit Default Min Max Description
Int Analog Out5 2661 Submenu Access the setup menu for internal analog out‐
put 5.
See Table Internal Analog Output 5 Menu
(2661).
Int Analog Out6 2669 Submenu Access the setup menu for internal analog out‐
put 6.
See Table Internal Analog Output 6 Menu
(2669).
Table 6-24 Internal I/O Module 4 (2809) Parameters
Parameter ID Unit Default Min Max Description
Module Type 2804 0 0 2 Set the type for internal I/O module 4. 0 = no
module installed.
Voltage 2564 V 120 -200 200 Set the required module voltage. Possible op‐
tions are:
• 24 V
• 120 V
Int Analog In10 2721 Submenu Access the setup menu for internal analog in‐
put 10.
See Table Internal Analog Input 10 Menu
(2721).
Int Analog In11 2725 Submenu Access the setup menu for internal analog in‐
put 11.
See Table Internal Analog Input 11 Menu
(2725).
Int Analog In12 2731 Submenu Access the setup menu for internal analog in‐
put 12.
See Table Internal Analog Input 12 Menu
(2731).
Int Analog Out7 2677 Submenu Access the setup menu for internal analog out‐
put 7.
See Table Internal Analog Output 7 Menu
(2677).
Int Analog Out8 2685 Submenu Access the setup menu for internal analog out‐
put 8.
See Table Internal Analog Output 8 Menu
(2685).
Parameter Assignment/Addressing
6.6 Options for Drive Menu (2) - second part
NXGPro+ Control Manual
Operating Manual, A5E50491925A 115