Siemens SINAMICS PERFECT HARMONY GH180 - Page 175

Parameter ID Units Default Min Max Description
Set SOPCon󹪝gFile7_O 9193 defaults.sfg Set the name of con󹪝guration 󹪝le 7 to be
used with corresponding SOP 󹪞ag 7.
Set SOPCon󹪝gFile8_O 9194 defaults.sfg Set the name of con󹪝guration 󹪝le 8 to be
used with corresponding SOP 󹪞ag 8.
Table 6-103 Parameter Menu for Slave Con󹪝guration
Parameter ID Parameter ID
Motor Menu
Motor kW rating 1010 50 Percent Break Point 1156
Motor frequency 1020 100 Percent Break Point 1157
Full load speed 1030 Maximum Load Inertia 1159
Motor voltage 1040 Motor trip volts 1160
Full load current 1050 Overspeed 1170
No load current 1060 Underload enable 1180
Leakage inductance 1070 I underload 1182
Stator resistance 1080 Underload timeout 1186
Inertia 1090 Motor torque limit 1 1190
Overload select 1130 Regen torque limit 1 1200
Overload pending 1139 Motor torque limit 2 1210
Overload 1140 Regen torque limit 2 1220
Overload timeout 1150 Motor torque limit 3 1230
0 Percent Break Point 1152 Regen torque limit 3 1240
10 Percent Break Point 1153 Phase Imbalance Limit 1244
17 Percent Break Point 1154 Ground Fault Limit 1245
25 Percent Break Point 1155 Ground Fault Time Const 1246
Drive Menu
Control loop type 2050 Skip center freq 3 2370
Ratio control 2070 Skip bandwidth 1 2380
Speed fwd max limit 1 2080 Skip bandwidth 2 2390
Speed fwd min limit 1 2090 Skip bandwidth 3 2400
Speed fwd max limit 2 2100 Freq avoid accel time 2410
Speed fwd min limit 2 2110 Spinning load mode 2430
Speed fwd max limit 3 2120 Scan end threshold 2440
Speed fwd min limit 3 2130 Current Level Setpoint 2450
Speed rev max limit 1 2410 Current ramp 2460
Speed rev min limit 1 2150 Max current 2470
Speed rev max limit 2 2160 Frequency scan rate 2480
Speed rev min limit 2 2170 Cond. stop timer 2500
Speed rev max limit 3 2180 Cond. run timer 2510
Speed rev min limit 3 2190 Min cells/phase count (n/3) 2540
Accel time 1 2270 Fast bypass 2600
Decel time 1 2280 Phase I gain 2710
Parameter Assignment/Addressing
6.19 Options for Multiple Con󹪝guration Files
NXGPro+ Control Manual
Operating Manual, A5E50491925A 173