Siemens SINAMICS PERFECT HARMONY GH180 - Page 369

Re-displaying the Version Number
Use the display version number (8090) function in Meter Menu (8) to re-display the version
number.
The version number is displayed on the identi󹪝cation/version screen.




+$1'
,727
9/76
530
'(0'
02'(
V e r s i o n # . # . # D a t e
S i e m e n s H a r m o n y
Figure 9-26 Identi󹪝cation/version screen and meter display
Description of the Meter Display
The meter display screen contains 󹪝ve 󹪝elds that are monitored and updated dynamically.
• MODE: operational mode
• DEMD: velocity demand
• RPM: calculated revolutions per minute
• VLTS: motor voltage
• ITOT: total output current
The value or state of each 󹪝eld is shown dynamically in the second column of the display.
5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
)L[HGGLVSOD\
ILHOG
8VHUGHILQHG
GLVSOD\ILHOGV
/LQH
ILHOG
QDPH
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
02'(
Figure 9-27 Dynamic Programmable Meter Display
[MODE] 󹪝eld
The [MODE] 󹪝eld is 󹪝xed.
The last four 󹪝elds on the display contain parameter values that can be de󹪝ned by the user.
All four variable displays can be selected from a pick list using the display parameters (8000).
The [MODE] 󹪝eld displays the current operational mode of the system.
This 󹪝eld can have any one of the displays summarized in Table Line 1 of mode display
depending on the current operational mode or the current state of the drive.
Software user interface
9.2 Multi-Language Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 367