Siemens SINAMICS PERFECT HARMONY GH180 - Page 370

Rollback [RLBK] Mode
The following 󹪝gure depicts the display in rollback mode.
)L[HGGLVSOD\
ILHOG
/LQH
ILHOG
QDPH
8VHUGHILQHG
GLVSOD\ILHOGV
5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
5/%.
Figure 9-28 Dynamic Programmable Meter Display in Rollback Mode
The KYPD 󹪝eld displays the current operational mode of the system.
This 󹪝eld can have any one of the displays summarized in Table Line 2 of mode display
depending on the current operational mode or the current state of the drive.
Regeneration [RGEN] Mode
The following 󹪝gure depicts the display in regeneration mode.
)L[HGGLVSOD\
ILHOG
/LQH
ILHOG
QDPH
8VHUGHILQHG
GLVSOD\ILHOGV
5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
5*(1
Figure 9-29 Dynamic Programmable Meter Display in Regeneration Mode
Modifying Parameter Values
The following sections illustrate the steps to take if attempting to locate and change the
following parameters:
• Ratio Control
• Motor Frequency
Example for changing ratio control parameters:
The metering display shows the commanded speed reference in percent.
Software user interface
9.2 Multi-Language Keypad
NXGPro+ Control Manual
368 Operating Manual, A5E50491925A