System Overview
1-11
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
Components
The components of the SINUMERIK 802D sl control system are:
S CNC operator panel (PCU) with NC full keyboard (upright or broad format)
S Machine control panel (MCP)
Incorporates all keys and switches required for the operation of a machine (milling
machine).
S I/O module PP72/48
The PP72/48 I/O module is a straightforward and low-cost module (without a separate
housing) within the framework of an automation system based on PROFIBUS DP for
connecting digital inputs/outputs.
The module offers the following main features:
– PROFIBUS DP connection (max 12 Mbits/s)
– 72 digital inputs and 48 digital outputs
– On-board status display via 4 diagnostic LEDs
To supply the module and the digital outputs, an external voltage source (+24 V DC) is
required.
S Drive units
– SINAMICS S120
The communication between the SINUMERIK 802D sl control system and the
SINAMICS S 120 drive is provided via the DRIVECLiQ communication system
(Drive Component Link with IQ).
System software
The following system software is installed in the retentive internal memory of the PCU of
each SINUMERIK 802D sl by default:
S Boot software – starts the system
S Human Machine Interface (HMI) software – realizes all operator functions
S NCK software (NC Kernel) – realizes all NC functions. It controls up to 5 axes (2 axes
can be configured as spindles).
S Programmable Logic Control (PLC) software – executes the integrated PLC user
program cyclically.
Siemens Automation Parts
To Next Page
Loading...
