Siemens SINUMERIK 802D sl - Page 130

10.1 Creating a drive project OFFLINE
Creating a Drive Project
10-128
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
169.254. 11. 23
255.255. 0 . 0
Fig. 10-8 Alternative configuration
8. Add the following (see Fig. 10-9):
– a new drive unit with the name Machine Tool V1_2,
– a device: SINAMICS
– a type in 802D
– version V2.2 and
– bus address 5 with PPI (with TCP/IP, the bus address can be freely selected).
To add the components and data listed above, use the relevant list boxes for selection
and click on Insert button.
Note
Section 10.1.2 shows you how to configure the drive unit and its components.