Siemens SINUMERIK 802D sl Instruction Manual

10.3 Creating a drive project ONLINE
Creating a Drive Project
10-154
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
5. Confirm the following queries and messages by choosing OK:
– Interactive screenform “Reset to default settings?”
– Interactive screenform “Default settings have been restored”
– Interactive screenform “Data have been successfully copied from RAM to ROM”
Double-click on
Automatic configuration.
Fig. 10-51 Automatic configuration
6. In the Project Navigator, double-click on Automatic configuration under the drive unit.
Click on
Start automatic configuration.
Fig. 10-52 Automatic commissioning
7. Click on the Start automatic configuration button.
STARTER will automatically search for all drive unit components connected correctly and
will load them automatically into STARTER. In our case, it has detected a drive.

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English