Siemens SINUMERIK 802D sl Instruction Manual

Machine and Setting Data 802D
A.1 List of machine data
A-197
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
217 USER_CLASS_WRITE_CYCLES
decimal Protection level for “Write cycles” immediately 3/3
0 3 0 7 BYTE
218 USER_CLASS_WRITE_RPA
decimal Protection level write R parameters immediately 3/3
0 3 0 7 BYTE
219 USER_CLASS_SET_V24
decimal Protection level for “Set V24” immediately 3/3
0 3 0 7 BYTE
221 USER_CLASS_DIR_ACCESS
decimal Protection level for directory access immediately 3/3
0 3 0 7 BYTE
222 USER_CLASS_PLC_ACCESS
decimal Protection level for PLC project immediately 2/2
0 3 0 7 BYTE
223 USER_CLASS_WRITE_PWA
decimal Protection level for protected working area immediately 2/3
0 7 0 7 BYTE
247 V24_PG_PC_BAUD
Bit pattern PG: Baud rate (300, 600, 1200, 2400, 4800, 9600, 19200, 38400) immediately 3/3
0 7 0 7 BYTE
280 V24_PPI_ADDR_PLC
PLCstation address POWER ON 3/3
2 0 126 BYTE
281 V24_PPI_ADDR_NCK
NCKstation address POWER ON 3/3
3 0 126 BYTE
289 CTM_SIMULATION_TIME_NEW_POS 10 (K1)
decimal Simulation of actual-value refresh rate immediately 3/4
0 100 0 4000 INTEGER
290 CTM_POS_COORDINATE_SYSTEM 10 (K1)
decimal Position of the coordinate system immediately 3/4
0 2 0 7 BYTE
291 CTM_CROSS_AX_DIAMETER_ON 10 (K1)
decimal Diameter for “Transverse axis active” immediately 3/4
0 1 0 1 BYTE
292 CTM_G91_DIAMETER_ON 10 (K1)
decimal Incremental feed immediately 3/7
0 1 0 1 BYTE
305 G_GROUP1
decimal User-oriented G group for position display immediately 3/7
0 1 1 1000 INTEGER
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English