EasyManuals Logo

Siemens SINUMERIK Commissioning Manual

Siemens SINUMERIK
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #205 background imageLoading...
Page #205 background image
Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
199
; the data or on scrolling through the list and the
; number of visible lines in the list is used to smaller than
; NumLinesPerReq. If data exchange between the HMI and NCK
; proceeds slowly (with the NCU 810 D), this value should be
; reduced to 17 in order to achieve a response time of
; around 1 s when retrieving data from a complete list
; in the background. The setting applies to all lists
; for which no individual settings have been made.
; Individual settings are useful if a list contains a large
; number of columns.
; In this case the value should be lowered to about 10 or 5.
; Too many columns in a list that is in frequent use
; is not recommended, because the time needed to retrieve
; data for the entire list would be too long and the user would have
to
; wait a long time for the display.
; To set an individual list to individual setting, add the following
line
; to the section (e.g. [2_ToolList]) of the corresponding list:
; "NumLinesPerReq".
; Use 27 for NumLinesPerReq=27 from Version P4.3.8!
; Up until P4.3.8 the value 7 worked well.
; Width of the bitmap image for the current tool and the
; current tool magazine location in the list displays.
; Unit: number of characters; the width of a character is
; set by "ColumnWidthTwipsPerAlphaCharacter" or
; "ColumnWidthTwipsPerNumericCharacter". Lowest value: 1,
; highest value: 32, default: 5
; User-defined images can also be used:
; if the file name is specified without a path or with the path
MMC2,
; then the system searches for the bitmap file in the directories
"user", "oem",
; "add_on" and "mmc2". ; The first hit is then
; used. It is not advisable to generate user-defined bitmaps
; that are too large. The ratio of width to height should
; roughly correspond to the display in the lists, to avoid
; distorting the display.
; Use WidthOfActBitmapsInCharacters = 7, if $SC_WEAR_TRANSFORM <> 0
; and G56-Reset-Value <> TOWSTD
WidthOfActBitmapsInCharacters = 5
WhichActChannelText=ChannelName,4
; default, show first 4 characters of channel name in lists actual
; tool indicator
; WhichActChannelText=ChannelNumber ;show channel number in lists
; actual tool indicator
; If you need to display more characters of channel name, please
; increase "WidthOfActBitmapsInCharacters".
; For better readability modify bitmaps or use lpaat.bmp,
lpaatd0.bmp,

Table of Contents

Other manuals for Siemens SINUMERIK

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK and is the answer not in the manual?

Siemens SINUMERIK Specifications

General IconGeneral
InterfaceEthernet, PROFIBUS, PROFINET, USB
Programming LanguagesDIN/ISO
DisplayTFT color display
CompatibilitySiemens drives and motors
SoftwareSINUMERIK Operate
Control Unit TypeCNC (Computer Numerical Control)
Safety FunctionsIntegrated safety functions up to SIL 3/PLe

Related product manuals