Siemens SINUMERIK

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
215
21= <EndOfList>
[2_ToolList]
MultiLine=MULTI
NrOfFixedColumns=1
1= NO, 4, NO
2= MagNo, 4, MagNo
3= ToolInPlace, 3, ToolInPlace
4= TC_TP2, 11, TC_TP2
5= TC_TP1, 5, TC_TP1
6= TC_MPP6, 5, TC_MPP6
7= CuttEdgeNo, 1, CuttEdgeNo
8= TC_DP1, 4, TC_DP1
9= TC_DP3, 11, TC_DP3
10= TC_DP4, 11, TC_DP4
11= TC_DP5, 11, TC_DP5
12= TC_DP6, 11, TC_DP6
13= TC_MPP2, 4, TC_MPP2
14= <EndOfList>
[3_ToolList]
NrOfFixedColumns=3
1= NO, 4, NO
2= MagNo, 4, MagNo
3= ToolInPlace, 3, ToolInPlace
4= TC_TP2, 11, TC_TP2
5= TC_TP1, 5, TC_TP1
6= TC_MPP6, 5, TC_MPP6
7= TC_TP3, 1, TC_TP3
8= TC_TP4, 1, TC_TP4
9= TC_TP5, 1, TC_TP5
10= TC_TP6, 1, TC_TP6
11= TC_DP3@E1, 11, e1TC_DP3
12= TC_DP3@E2, 11, e2TC_DP3
13= TC_DP3@E3, 11, e3TC_DP3
14= TC_TP9, 1, TC_TP9
15= TC_MOP1, 7, TC_MOP1
16= TC_MOP2, 7, TC_MOP2
17= TC_MOP3, 7, TC_MOP3
18= TC_MOP4, 7, TC_MOP4
19= <EndOfList>
[1_ActList]
MultiLine=SINGLE
NrOfFixedColumns=1
NumLinesPerReq = 11