To Next Page

To Previous Page

Tool management

6.7 Start-up of code carrier

HMI Advanced (IM4)

Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0

265

Note

This format for the beginning of a comment is used only in the description file for code

carriers. Otherwise, the beginning of a comment is introduced by a semicolon (;).

Datalen

DATALEN=CONST | VARIABLE 0x<delimiter>

The following data have a constant (CONST) or a variable (VARIABLE) data length. Data

with variable length are terminated with 0x<delimiter>.

Example:

DATALEN=VARIABLE 0x0A ' variable data length, delimiter LF

DEFINE_KEYWORD

DEFINE_KEYWORD=<keyword> <value><keyword> := any user keyword for indicating a

new data section on the code carrier

Definition of the keyword <keyword> with the value <value>

Example:

DEFINE_KEYWORD=DATA _OEM "OEM"

DEFINE_KEYWORD=DATA_SIN840D 0x840D

A keyword defined by DEFINE_KEYWORD that identifies a new data section on the code

carrier. The item following <keyword> in the code carrier description file must contain the

value <value> defined with DEFINE_KEYWORD.

Item

Item<n>=<line>

<n> := Consecutive number of code carrier data, ascending from 1 without gaps

<Code carrier data format> :

<dialog variable> : Assignment of code carrier to dialog datum

If a user keyword is defined immediately before Item<n>, <dialog variable> takes the value

Conversion rule for code carrier data <n>

Example:

Item1 32 ASCII T3 '

Convert tool identifier to/from

Tool dialog data 3

Siemens SINUMERIK Commissioning Manual

Other manuals for Siemens SINUMERIK