Ionics Instruments 2004 Page 10-13 DLM 30007-08 Rev. A
order shipping supplies. Under no circumstances should you try to pack the
analyzer in anything other than the original shipping container. A Return
Authorization Number must be obtained from Ionics Instrument Business
Group before shipping the analyzer.
WARNING
If the analyzer is returned in anything other than an Ionics Instruments shipping
container, you will be charged for any damage that occurs during shipping.
Preparing the Analyzer for Return Shipment
1. Turn the analyzer on. If necessary, select STOP TOC and press
ENTER.
2. From the MAIN menu, scroll to SETUP and press ENTER. Then
scroll to REAGENTS ON-LINE FLOW RATES and press ENTER.
3. Set the acid flow rate to 0 by selecting ACID FLOW RATE, entering a
flow rate of 0, and pressing ENTER three times. Press CLEAR to
return to the FLOW RATES screen.
4. Set the oxidizer flow rate to 0 by selecting OXID FLOW RATE,
entering a flow rate of 0 and pressing ENTER three times. Press
CLEAR to return to the FLOW RATES screen.
5. Press CLEAR three times to return to the MAIN menu, scroll to
START TOC, and press ENTER.
6. The analyzer will empty the Acid and Oxidizer syringes and display
“Emptying Acid Syringe” and “Emptying Oxidizer Syringe” messages
on the front panel display.
7. After the messages have been cleared and the clock indicating time
to next measurement (upper right-hand corner of the screen) has
started, stop analysis, and turn off power to the analyzer.
8. Disconnect the sample inlet tubing and the waste tubing from the
right-hand-side of the analyzer.
9. Remove any printer, alarm, analog output, or computer cables and
the power cord connected to the analyzer.
10. Remove the Acid and Oxidizer Reagent containers from the analyzer:
To Next Page
Loading...