Ionics Instruments 2004 C-1 DLM 30007-08 Rev. A
APPENDIX C - TURBO TOC ANALYZERS
Introduction
Turbo sampling mode is an option on a Sievers 800 Series TOC Analyzer that
is achieved through specific firmware. Analyzers configured with this option
are designated as the “Turbo” version of the model number. This mode is
useful for monitoring recycle or reclaim water in semiconductor facilities where
rapid response is of primary concern. When operated in the Turbo mode, the
analyzer responds to a step change with an initial response in 3 minutes and
90% of the final value in 3.5 minutes. Results are reported every 3 to 4
seconds.
NOTE
During a reagent syringe refill, there is a 3 to 4 minute delay, during which no
new data are available. Refills will occur approximately every 4 hours.
To Next Page
Loading...
Need help?
General
