Ionics Instruments 2004 Page 11-2 DLM 30007-08 Rev. A
11 RAM CARDS, CARD READER, AND RAMReader SOFTWARE
All of the data collected is stored on a RAM card. The data can be viewed
either by using the HISTORY options from the RunTime menu while the
analyzer is operating or by using the HISTORY option from the MAIN menu.
The RAM card may be removed from the analyzer and the data downloaded to
a PC using a RAM card reader device and the RAMReader software program.
To read the data stored on the RAM card, a RAM card reader device must be
installed on the computer, and RAMReader software must be installed on the
computer.
Installing the Card Reader Hardware
Follow the instructions supplied with the card reader for installation. Select
the appropriate driver and follow the instructions. It is recommended to use an
external card reader device instead of the incorporated PCMCIA slots on
laptop computers.
NOTE
Data from the RAM card is transferred via one of the parallel printer ports. If
both ports are being used or there is only one printer port, disconnect the printer
cable in order to transfer data. For convenience, a printer switching box,
available from computer stores, should be installed on the printer port in order
to easily switch between the printer and the card reader.
Installing RAMReader Software
Ionics Instruments recommends using the RAMReader software program.
Follow the instructions supplied with the program for installation. Instructions
for installation on all Windows operating systems (except Windows NT) are
included.
To order the RAMReader software program (part number ASW-80010),
contact Ionics Instruments Customer Service at (800)255-6964.
To Next Page
Loading...