Ionics Instruments 2004 Page 4-1 DLM 30007-08 Rev. A
4 INSTALLATION
Reading this manual will help familiarize you with both the analyzer design and
function. If additional assistance is needed, contact Ionics Instruments at
(800)255-6964. Installation and training by a qualified service technician can
also be provided.
NOTE
ORIGINAL PACKING MATERIALS MUST BE SAVED! If for any reason
the analyzer must be returned, it MUST be packed in the original carton to
ensure that no damage occurs during shipment. There will be a charge if the
analyzer must be repackaged for return shipment. Insure the analyzer for the
return shipment.
WARNING
Hazardous chemical reagents (ammonium persulfate and phosphoric acid) are
used in the analyzer. Before installing the reagents, please read the Material
Safety Data Sheets (MSDS) contained in a pouch on the top of the reagent
shipping box for proper handling precautions and spill or leak procedures.
Unpacking and Inspecting
Open the two shipping boxes and verify that they contain the following:
Sievers 800 TOC Analyzer
Literature and manual
Accessory package containing:
3 meters of sample inlet tubing with in-line filter
Spare pump tubing
(4) .6-meter lengths of 1/16"-OD Teflon tubing with 1/16"
Valco
nuts and ferrules for container sampling
6 meters of 3/8" OD vinyl tubing for waste line
Spare plastic-barbed water fitting
3/32" Allen wrench
1/4" Open-end wrench
Water bottle
Analyzer power cord
To Next Page
Loading...
Need help?
General
