Section 04 ENGINE MANAGEMENT (SDI)
Subsection 01 (OVERVIEW)
NOTE: Sensor failures will not lead automatically
to a limp home mode. The check engine LED will
turnonandinsomecasesthebeeper.
The engine RPM may be limited if some critical
components fail. In this case, releasing throttle
and letting the engine returning to idle speed may
allow normal operation to come back. If it does
not work, try removing and reinstalling the tether
cord cap on DESS post.
These performance-reduced modes allow the rid-
er to go back home which would not be possible
without this advanced system. Refer to the DIAG-
NOSTIC PROCEDURES for a complete chart.
DIAGNOSTIC MODE
The malfunctions are recorded in the memory
of the ECM. The memory of the ECM can be
checked using the VCK (Vehicle Communication
Kit) (P/N 529 035 981) to see the fault codes. Re-
fer to the DIAGNOSTIC PROCEDURES section.
mmr2005-124 125
To Next Page
Loading...
