Section02ENGINE
Subsection 05 (MAGNETO SYSTEM)
CPS
Inspection
Always check CPS before changing it. Refer to
ENGINE MANAGEMENT.
Removal
To replace the CPS, remove or disconnect the fol-
lowing:
– magneto flywheel no. 1
– grommet from crankcase where CPS wire exits
magneto housing
– retaining screws no. 7
– CPS no. 6 and carefully pull wires.
Installation
For installation, reverse the removal procedure.
Remove the old sealant at CPS location then apply
new one. Screw CPS then stick the CPS wires in
the sealant.
mmr2005-116 39
To Next Page
Loading...
