Section05ELECTRICALSYSTEM
Subsection 05 (ACCESSORIES AND LIGHTING SYSTEM)
A33E1PB
7
Crazy Needle
Check wire connections on pin 18, 19, 20 and 21
of tachometer connector.
A33E1PC
20 181921
TAILLIGHT
Bulb Replacement
Unscrew lens screws to expose bulb.
Push the bulb in and hold while turning counter-
clockwise to release.
Install the new bulb by first pushing in while turn-
ing clockwise.
Removal
Remove the radiator cover by removing the retain-
ing screws.
Remove trunk behind seat.
Disconnect taillight connector.
Remove the wires from connector. Open the con-
nector on wire side then with a small tool extract
the wires from the connector.
A33E1OA
NOTE: Notethelocationofeachwire.
Summit Highmark and Summit Highmark X
Unscrew the screws retaining the rack to the side
of frame.
Unscrew the other screws that attach the rack
near the radiator.
All Models
Unscrew taillight lens and pull the wire.
NOTE: Attachacordattheendofwiretoreinstall
the new wire easily.
Installation
The installation is the reverse of the removal pro-
cedure.
VISOR OUTLET
Removal
Remove the console.
Unplug the visor connector.
Unscrew visor outlet.
Tes t
Unplug the visor connector.
Using the multimeter FLUKE 111 (P/N 529 035
868), check voltage between RED/YELLOW and
BLACK wires. The obtained value should be
±12Vdc.
Before changing the visor outlet, try another ac-
cessory, if the accessory does not work, change
visor outlet.
Installation
The installation is the reverse of the removal pro-
cedure.
184 mmr2005-130
To Next Page
Loading...
