Section02ENGINE
Subsection 07 (TOP END)
A35C0ZA
CAUTION: Do not pry out combustion cham-
ber. It could damage the surface contact of
cylinder head.
A35C10A
Cylinder Block
Unscrew cylinder block screws no. 7 and no. 8
then remove the cylinder block no. 9.
NOTE: If engine is in vehicle, lean cylinder block
toward rear to withdraw.
Piston
With a pointed tool inserted in piston notch, re-
move circlips no. 11 from piston no. 6.
A02C29A
TYPICAL
Using piston pin puller/installer (P/N 529 036 002),
extract piston pin from piston.
A02C2CA
TYPICAL — PISTON PIN EXTRACTION
Decompressor
Mach Z
Do not remove decompressor plug no. 23 need-
lessly.
CLEANING
Discard all gaskets and O-rings. Use Loctite
Chisel (P/N 413 708 500) to clean mating sur-
faces.
Clean all metal components in a non-ferrous metal
cleaner.
54 mmr2005-117
To Next Page
Loading...
Need help?
General
