Section09BODY/FRAME
Subsection 01 (BODY)
Cover Replacement
Remove the old seat cover. Check the foam and
replace it if necessary.
Install staples with an electric tacker such as
Arrow tacker ETN-50 or with a manual tacker
such as Arrow tacker T-50.
NOTE: For an easier installation, it is highly recom-
mended to use an electric tacker.
Ensure that the seat rest firmly against a hard sur-
face such as a piece of wood. This is done to get
the staples completely pushed in place.
A35H0HA
2
1
TYPICAL
1. Piece of wood
2. Tacker
After seat cover installation, cut all around the ex-
cess of material.
Installation
The installation is the reverse of removal proce-
dure.
NOTE: The seat must be inserted under console.
PLASTIC MAINTENANCE
AND REPAIR
Maintenance
Clean the vehicle thoroughly, removing all dirt and
grease accumulation.
To clean use a soft clean cloth and either soapy
water or isopropyl alcohol.
To remove grease, oil or glue use isopropyl alco-
hol.
CAUTION: Do not apply isopropyl alcohol or
acetone directly on decals.
CAUTION: The following products must not be
used to clean or wax any of the plastic compo-
nents used on the vehicles:
– gasoline
– brake fluid
– kerosene
– diesel fuel
– lighter fluid
– varsol
– naphtha
– acetone
– strong detergents
– abrasive cleaners
– waxes containing an abrasive or a cleaning
agent in their formula.
Apply wax on glossy finish only. Protect the ve-
hicle with a cover to prevent dust accumulation
during storage.
CAUTION: If for some reason the snowmobile
has to be stored outside, it is preferable to cov-
er it with an opaque tarpaulin. This will prevent
the sun rays from affecting the plastic compo-
nents and the vehicle finish.
Repair
The very first step before repairing plastic materi-
als is to find out exactly which type of material is
involved.
A35H0IA
37
6
1
5
2
4
308 mmr2005-143
To Next Page
Loading...
